Flushing Library Contract eBook

Division 01 - DOC STANDARDGENERAL CONDITIONS SINGLE CONTRACT PROJECTS Issue Date June 01, 2013 Revised - January 15, 2015

.. O>"Y<••••n"NT°' DESIGN + CONSTRUCTION

~,.,

SECTION 01 35 06 GENERAL ELECTRICALREQUIREMENTS

PARTI-

GENERAL

1.1 RELATED DOCUMENTS:

A. The following documents apply to all required work for the Project: (1) the Contract Drawings, (2) the Specifications, (3) the General Conditions, (4) the Addendum, and (5) the Contract [City of New York Standard ConstructionContract].

1.2 SUMMARY: A.

This Section sets forth the General Requirements applicable to electrical work for the Project. Such requirements are intended to be read in conjunction with the Specifications and Contract Drawings for the Project. In the event of any conflict between the requirements set forth in this Section and the requirements of the Project Specifications and/or the Contract Drawings, whichever requirement is the most stringent, as determined by the Commissioner, shall take precedence. B. This Section includes the following: 1. Procedurefor ElectricalApproval 2. Submittals 3. Electrical Installation Procedures 4. Electrical Conduit System Including Boxes (Pull, Junction and Outlet) 5. ElectricalWiring Devices 6. Electrical Conductors and Terminations 7. Circuit ProtectiveDevices 8. DistributionCenters 9. Motors 10. Motor Control Equipment 11. Schedule of Electrical Equipment

1.3 RELATEDSECTIONS: Includewithout limitation the following:

A. B.

Section 01 10 00 Section 01 33 00

SUMMARY

SUBMITTAL PROCEDURES

C. Section 01 35 03 D. Section 01 42 00

GENERALMECHANICAL REQUIREMENTS REFERENCES CLOSEOUT PROCEDURES CONTRACT RECORDDOCUMENTS

E. F.

Section 01 77 00 Section 01 78 39

1.4 DEFINITIONS:

A. WIRING: means both wire and raceway (rigid steel, heavy wall conduit unless specifically indicated otherwise). B. POWERWIRING: meanswiring from a panel board or other specified source to a starter (if required) then to a disconnect (if required), then to the final point of usage such as a motor; unit or device. C. CONTROL and/or INTERLOCK WIRING: means that wiring that signals the device to operate or shut down in response to a signal from a remote control device such as a temperature, smoke, pressure, float,

GENERAL ELECTRICALREQUIREMENTS 01 35 06 - 1